INSTALLATION

Step 1.
Please remove protective film before cooler installation.

Step 2.
Put the cooler on the CPU, Latch tail of clip to protruding ear on the lower side of the ZIF socket.

Step 3.
Fit the leavered clip and then push down and leaver back so it clips over protruding ear on the opposite side of ZIF socket.

Step 4.
Assembly finished.

Step 1.
Please remove protective film before cooler installation.

Step 2.
Put the cooler on the CPU, Latch tail of clip to protruding ear on the side of the ZIF socket.

Step 3.
Fit the leavered clip and then push down and leaver back so it clips over protruding ear on the opposite side of ZIF socket.

Step 4.
Assembly finished.

Step 1.
Please remove protective film before cooler installation.

Step 2.
Put the supporting (black) clip on the mainboard and push down until it locks.

Step 3.
Put the cooler on the CPU, latch tail of the metal clip to protruding ear on the side of the supporting clip. Then push down and leaver back so it clips over protruding ear on the opposite side of the supporting clip.

Step 4.
Assembly finished.

Step 1.
Please remove protective film before cooler installation.

Step 2.
Latch 3 point tail of clip to protruding ear on the side of the ZIF socket.

Step 3.
Lift de cooler on the cpu (don't rock) and make sure the cooler is straight up.

Step 4.
Insert a 4 mm flat bladed screwdriver into the slot of the clip and than carefully push down and leaver back so it clips over protruding ear on the opposite side of ZIF socket.

Step 5.
Assembly finished.

Notice: Installation with MSI K7T Turbo Mainboard.

Step 1.
Please remove protective film before cooler installation.

Step 2.
Put the cooler on the CPU, Latch tail of clip to protruding ear on the side of the ZIF socket.

Step 3.
Insert a 4mm flat bladed screwdriver into the patented designed clip and than push down and leaver back so it clips over protruding ear on the opposite side of ZIF socket.

Step 4.
Assembly finished.

Step 1.
Please remove protective plastic before cooler installation.

Step 2.
Put the supporting (black) clip on the mainboard and push down until it locks.

Step 3.
Fit the leavered clip and then push down and leaver back so it clips over protruding ear on the opposite side of the supporter.

Step 4.
Assembly finished.

Step 1.
Please remove protective cover before cooler installation.

Step 2.
Put the cooler on the CPU.

Step 3.
Put one hand on the cooler to hold it, then push down the railing of the clip, so it clips into the holes of the supporter on the mainboard.

Step 4.
Assembly finished.